Dell Wyse Z90S7 Посібник з монтажу - Сторінка 11

This chapter contains information for users of Wyse X class mobile thin clients who

must install new flash.

Small Phillips screwdriver

•

WARNING: Flash modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD. Before you

remove or install a module, touch any metal part of the chassis and keep that contact

with the chassis during the installation process.

Procedures

CAUTION: Follow all precautions listed in the Quick-Start Guide that came with your

mobile thin client for disconnecting and reconnecting the mobile thin client.

1. Perform a proper shutdown of the mobile thin client by closing all files and ending

your session, and then pressing the power button to turn off the mobile thin client.

2. Unplug the power cord and power adapter, and then remove any other cables from

the mobile thin client.

3. Position the mobile thin client to access the bottom cover, and then remove the

screws from the cover using a small Phillips screwdriver as shown in Figure 6.

Figure 6 Removing the bottom cover screws

4. Lift the bottom cover to remove it and expose the flash module as shown in

Figure 7.

WARNING: Flash modules may be susceptible to damage by Electro-Static

Discharge (ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis and keep

that contact with the chassis during the installation process.