Allied Telesis SB251-08 Примітка до випуску - Сторінка 2

Переглянути онлайн або завантажити pdf Примітка до випуску для Програмне забезпечення Allied Telesis SB251-08. Allied Telesis SB251-08 12 сторінок. Patch for switchblade 4000 series switches and at-9800 series switches

Друкувати сторінку

Some of the issues addressed in this Release Note include a level number. This

number reflects the importance of the issue that has been resolved. For details

on level numbers, please contact your authorised distributor or reseller.

Features in SB251-08

Patch SB251-08 includes all issues resolved and enhancements released in

previous patches for Software Release 2.5.1, and the following enhancements:

PCR: 03251

Module: SWI

A fatal error occurred when the ADD SWITCH TRUNK command specified

an invalid port. This issue has been resolved.

PCR: 03414

Module: SWI

A fatal error occurred when removing a line card from a SwitchBlade if STP

was enabled. This issue has been resolved.

PCR: 03466

Module: SWI

System performance was low when adding large numbers of entries to

CAM. This issue has been resolved. CAM is now initialised to allow better

performance, especially for the addition of ARP and IP entries.

PCR: 03470

Module: SWI

The DELETE SWITCH TRUNK PORT command could cause an unrelated

port to stop forwarding packets, or learn new MAC addresses. This issue

has been resolved so that unrelated ports are not affected by the trunk group

port deletion.

PCR: 03509

Module: SWI

All IP routes were being added to all switch instances. This caused issues on

SwitchBlade line cards that did not have enough CAM to store the routes,

and the line card did not always need every route. IP routes are now only

added:

•

to a switch instance if the route was learned on that instance

•

if the route is for an interface

•

if the route was added statically, or

•

if the switch instance has a CAM which is the same size or larger than

the CAM of the switch instance that the route was learned on.

PCR: 03518

Module: SWI

An issue exists where the CAM entry 0 in the VLAN Tag table is either not

updated or is being overwritten with invalid data. This PCR adds

debugging to trace the fault.

Patch Release Note

Level: 2

Level: 3

Patch SB251-08 for Software Release 2.5.1

C613-10361-00 REV H