Dell XPS One 24 Посібник з експлуатації - Сторінка 49

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Монітор Dell XPS One 24. Dell XPS One 24 50 сторінок. Service manual

Clearing CMOS Settings

CAUTION:

Before you begin any of the procedures in this section, follow the

safety instructions that shipped with your computer.

CAUTION:

The computer must be disconnected from electrical outlet to clear the

CMOS setting.

1 Follow the procedure in "Before You Begin" on page 9.

2 Remove the computer cover (see "Replacing the Computer Cover" on

page 11).

3 Locate the 2-pin CMOS jumper on the system board.

4 Move the 2-pin jumper plug from pins 3 and 2 to pins 1 and 2.

5 Wait for five seconds for the CMOS to clear.

6 Move the 2-pin jumper plug back to pins 3 and 2.

NOTE:

pins 3 and 2.

7 Replace the computer cover (see "Replacing the Computer Cover" on

page 11).

8 Turn on the computer.

9 The message CMOS settings wrong appears on the screen. Restart

the computer.

The message CMOS checksum error. Press F1 to run

setup. Press F2 to load default values and

continue appears on the screen.

10 Press <F2> to load default values and continue.

The computer will not turn on if you do not replace the 2-pin jumper on

System Setup