Dell PowerVault 201S Оновлення - Сторінка 2

Переглянути онлайн або завантажити pdf Оновлення для Зберігання Dell PowerVault 201S. Dell PowerVault 201S 4 сторінки. Dell powervault 20xs storage systems enclosure services expander module installation
Також для Dell PowerVault 201S: Посібник з монтажу стійки (26 сторінок), Інструкція із заміни Посібник із заміни (14 сторінок), Посібник (9 сторінок), Конфігурація (2 сторінок), Посібник з монтажу (48 сторінок)

If the two adjustable rail mounting flanges are not already attached to the support

rails, attach one flange to one of the support rails using two 10-32 x 1/2-inch

Phillips-head screws, as shown in Figure 1. Do not tighten the screws at this

time.

If the two rail mounting flanges are already attached to the support rails, ensure

that the two 10-32 x 1/2-inch Phillips-head screws are slightly loose, allowing the

flanges to slide freely.

support rail

Place the flange of the support rail assembly behind the right front vertical rail of

the rack. Thread two 10-32 screws with a flat washer and a square alignment

washer and push them through the front vertical rail of the rack and into the two

center-most screw holes of the rail mounting flange (see Figure 2). Ensure that

the rail is centered vertically within the 3U mounting area.

Tighten the screws. Ensure that the full surface of the support rail flange comes

in contact with the surface of the vertical rail.

adjustable rail

mounting flange