Dell PowerVault 221S Посібник з експлуатації - Сторінка 23
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Зберігання Dell PowerVault 221S. Dell PowerVault 221S 33 сторінки. Dell powervault 220s and 221s systems scsi drive enclosure
Також для Dell PowerVault 221S: Посібник (44 сторінок), Повідомлення (28 сторінок), Оновлення прошивки (14 сторінок)
Друкувати сторінку
Removing and Replacing Parts : Dell PowerVault 220S and 221S Systems Service Manual
a. Using a standard screwdriver, detach the slide rail on the right (or hinge) side of the carrier from the metal carrier shield by bending away the metal tab located
beneath the rail that fastens the rail to the shield (see
Figure 13. Detaching the Carrier Slide Rail
b. Separate the rail from the carrier shield allowing enough space to access the pin holes.
c. From the inside of the drive carrier, insert the access pins into the holes labeled "S" (see
Figure 14. Configuring a SCSI Drive Carrier
d. Reassemble the slide rail to the carrier shield and bend the metal retaining tab back into place.
2. If you are replacing a hard drive in a carrier, perform the following steps to install the new hard drive into the carrier:
a. Remove the four screws that secure the hard drive to its carrier (see
b. Position the replacement hard drive into the drive carrier with the hard drive's controller board facing the carrier shield.
c. Align the hard drive with the carrier by sliding the hard drive against the stop at the back of the carrier.
d. Secure the hard drive to the carrier using the four screws you removed in step a (see
Figure 15. Installing the Hard Drive in the Carrier
file:///C|/Users/rishi_sood/Desktop/220s/en/sm/remove.htm[3/7/2013 12:09:15 PM]
Figure
13).
1 carrier shield
2 carrier slide rail
Figure
1 pin holes for SCSI configuration (labeled "S")
2 detached drive rail
3 access pins (insert from inside the rail)
Figure
15).
Figure
15).
1 carrier shield
14).