Dell PowerVault 715N Посібник з експлуатації - Сторінка 25
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Зберігання Dell PowerVault 715N. Dell PowerVault 715N 44 сторінки. Network attached storage
Також для Dell PowerVault 715N: Інструкція з оновлення (4 сторінок), Посібник користувача (31 сторінок)
Друкувати сторінку
3. If not already installed,
NOTICE:
The riser card must be properly seated in its system board connector before attempting to install an
expansion card.
4. Insert the expansion card's card-edge connector firmly into the riser card, and ensure that the mounting bracket
enters its slot on the chassis back panel (see
5. When the card is fully seated in the connector and the card-mounting bracket is in its slot, close the expansion-
card latch.
6. Connect any cables that should be attached to the card.
See the documentation that came with the card for information about cable connections.
7.
Replace the system
Riser Card
The riser card supports a single PCI expansion card and connects to the riser-card slot on the system board and the side
of the system chassis (see
CAUTION:
Read the safety instructions in your System Information document.
Riser Card Removal
1. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
2.
Remove the system
3.
Remove the expansion
4. Grasp the riser card on each end and lift it out of its slot on the system board. Use care to lift it out evenly so that
the metal tabs easily leave their slots on the chassis wall (see
Figure 12. Riser Card Removal
NOTICE:
The riser card must be properly seated in its system board connector before attempting to install an
expansion card.
When installing a replacement riser card, align
the system chassis. When properly aligned, the card-edge connector should be properly positioned. Firmly press the riser
card into its system board connector.
install the riser
card.
cover.
Figure
12).
cover.
card.
the tabs on the back of the riser card
Figure
11).
Figure
1 Riser-card slot
2 Riser card
3 Tabs
4 Slots on chassis
12).
with the mating slots on the wall of