Dell PowerVault 755N Початок роботи - Сторінка 4
Переглянути онлайн або завантажити pdf Початок роботи для Зберігання Dell PowerVault 755N. Dell PowerVault 755N 10 сторінок. Installing microsoft updates and service packs
Також для Dell PowerVault 755N: Посібник з експлуатації платформи (40 сторінок), Посібник з оновлення (10 сторінок)
Друкувати сторінку
When connecting external devices to the back panel of your system, use the following
guidelines:
•
•
For information about enabling, disabling, or configuring I/O ports and connectors,
see "Using the System Setup Program" in the User's Guide that came with the NAS
appliance.
•
Cable the NAS appliance to your Ethernet network.
4
Connect the PowerVault 750N NAS appliance to your Ethernet network using an
Ethernet cable and the integrated Intel
NAS appliance.
Connect the PowerVault 755N NAS appliance to your Ethernet network using an
Ethernet cable and one of the following connectors on the back of the NAS appliance:
•
•
For more cabling information, see the User's Guide that came with the appliance.
Install the AC power cables between the power supplies on the back of the system and
5
the electrical outlets.
For more information, see the User's Guide that came with the appliance.
1-2
Us i n g Yo u r A p pl i a n c e fo r t he Fi rs t T i m e
Check the documentation that accompanied the device for specific installation
and configuration instructions. For example, most devices must be attached to a
particular port or connector to operate properly. In addition, it is usually necessary
to install device drivers before the device can operate. Device drivers are normally
included with your operating system software, or with the device itself.
Always attach external devices while your system is turned off. Unless
documentation for the device specifies otherwise, power on the external device
before powering on the system again. (If the system does not seem to recognize
the device, try turning on the system before turning on the device.)
If you have external storage systems, connect them to the NAS appliance using
SCSI cables and the SCSI controller card connectors installed in the PCI slots.
For more information, see the documentation that came with your storage
systems.
Integrated Intel 10/100 NIC
Integrated 64-bit/66 MHz PCI 10/100/1000 Ethernet controller
®
10/100 NIC connector on the back of the