Dell PowerVault MD3620f Посібник з розгортання - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник з розгортання для Зберігання Dell PowerVault MD3620f. Dell PowerVault MD3620f 36 сторінок. Remote replication
Також для Dell PowerVault MD3620f: Посібник з конфігурації (22 сторінок), Посібник з монтажу (18 сторінок), Матриця підтримки (17 сторінок), Функціональний посібник (15 сторінок)

8 After the PowerVault MD1200 series expansion enclosure is configured as

an expansion enclosure of the storage array, restore the data that was

backed up in step 1.

After the PowerVault MD1200 series expansion enclosures are online, they

can be accessed as a part of the storage array.

Expanding With New PowerVault MD1200 Series Expansion Enclosures

Perform the following steps to attach new PowerVault MD1200 series

expansion enclosures to a PowerVault MD3600f series storage array:

NOTE:

Before adding the expansion enclosure(s), ensure that the storage array

software is installed and up to date. For more information, see the

support.dell.com/manuals.

1 Install the software and driver package included on the PowerVault

MD3600f series resource media. For information about installing the

software, see "Software Installation" on page 17.

2 Set up the MD1200 series expansion enclosure(s). For information about

setting up the MD1200 series expansion enclosure(s), see the Hardware

Owner's Manual at support.dell.com/manuals.

3 Using MDSM, update the RAID controller module firmware and

NVSRAM to the latest versions available on support.dell.com. From the

Enterprise Management Window (EMW), click Tools Upgrade RAID

Controller Module Firmware.

4 Stop I/O and turn off the solution:

Stop all I/O to the storage array and turn off affected host systems

attached to the storage array.

Turn off the storage array.

Turn off any expansion enclosure(s) in the affected system.

5 Cable the expansion enclosure(s) to the storage array.

6 Turn on the solution:

Turn on the expansion enclosure(s). Wait for the enclosure status

LED to light blue.

Turn on the storage array and wait for the status LED to indicate that

the unit is ready:

Support Matrix

Hardware Installation