Dell PowerVault NX1950 Посібник з розгортання - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник з розгортання для Зберігання Dell PowerVault NX1950. Dell PowerVault NX1950 38 сторінок. For vmware esx server software
Також для Dell PowerVault NX1950: Посібник з розгортання (34 сторінок), Важлива інформація Посібник (26 сторінок), Початок роботи (49 сторінок), Посібник з встановлення та усунення несправностей (48 сторінок), Посібник з оновлення (18 сторінок), Довідковий посібник (4 сторінок), Налаштування (2 сторінок), Використовуючи (2 сторінок), Посібник з конфігурації (11 сторінок)

Installing Your Operating System Using the Dell Systems Build and

Update Utility

The following section explains how to reinstall your Microsoft Windows

Unified Data Storage Server 2003 x64 operating system using the

Dell Systems Build and Update Utility available on the Dell Systems

Management Tools and Documentation media.

The Dell Systems Build and Update Utility installs the operating system

software, the Dell-specific device drivers, and additional components that are

not on the operating system media.

NOTICE:

When you install Windows Unified Data Storage Server 2003 x64 with the

Dell Systems Build and Update Utility, all data is erased from your internal hard

drives. Dell recommends that you back up your data before you perform this

procedure.

NOTE:

The Windows Storage Server wallpaper will be seen while the operating

system is being restored.

NOTE:

For the latest BIOS, firmware, and driver updates, see the Dell Support

website at support.dell.com.

To perform a clean installation of the operating system, perform the

following steps:

NOTE:

To restore your operating system, you can either locally boot from the

Dell Systems Build and Update Utility on your PowerVault NX1950 storage system

or you can configure the Dell remote access controller (DRAC) 5 and perform a

remote installation. For remote installation, configure the DRAC 5 and refer to the

DRAC 5 instructions for booting through virtual media.

1 If restoring locally, connect a keyboard, mouse, and monitor to your system.

2 Turn on your system.

3 Insert the Dell Systems Management Tools and Documentation media

into the system.

4 If you are not using the Dell Systems Build and Update Utility for the

first time, the Welcome to Dell Systems Build and Update Utility

window appears. Go to step 5.

Deployment Guide