Dell PowerVault TL4000 Важлива інформація Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Важлива інформація Посібник для Зберігання Dell PowerVault TL4000. Dell PowerVault TL4000 10 сторінок. Tape library
Також для Dell PowerVault TL4000: Примітки до випуску (3 сторінок), Початок роботи (38 сторінок), Питання (26 сторінок), Посібник із швидкого старту (7 сторінок), Посібник з програмного забезпечення (16 сторінок), Посібник з конфігурації (22 сторінок), Доповнення до посібника користувача (2 сторінок), Посібник для початківців (3 сторінок), Інструкції щодо вкладання (17 сторінок), Брошура (4 сторінок), Посібник користувача (20 сторінок)

•

LT03FH library drives with the firmware version (6AB1) cannot have

their firmware updated via the unit RMU interface.

To upgrade a LT03FH drive starting with firmware version 6AB1, use the

ITDT tool provided with the firmware upgrade package.

•

Erroneous grayed-out number is displayed in the No Cycles field when

executing diagnostics.

The TL2000/TL4000 shows the number of executed cycles performed

during the diagnostics cycle. On starting the diagnostics testing, a grayed-

out number is displayed in the Cycle Count window. The cycle count is

displayed only when the first full diagnostics cycle is complete.

•

Encryption configuration missing data.

The library-managed encryption setup is not able to determine which port

needs to be used for configuration. The library-managed encryption

configuration requires an IP address and the TCP port to access the

Encryption Key Manager (EKM) server. This information can be located in

the Health Monitor page of the EKM GUI.

•

By default, the EKM server is not configured to start as an operating

system service.

By default, the EKM server does not start automatically when the host is

rebooted. The user must configure this feature. For more information, see

the Dell PowerVault Encryption Key Manager User's Guide available on the

Dell Support website at support.dell.com.

•

A false LME failure is displayed if the library is licensed for library-

managed encryption (LME) and the user changes the configuration to

application-managed encryption (AME).

When a TL2000/TL4000 system is configured for library-managed

encryption and the user changes the library configuration to application-

managed encryption, the library posts a false LME Failure if the IP

address field is cleared (set to 0.0.0.0). This field is not required when the

library is configured for AME.

•

A No resources selected message is displayed when a user

attempts to perform a media move via the Remote Management Unit

(RMU) and the backup application has a Prevent Allow in the device.

Important Information