Dell SC180 Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Зберігання Dell SC180. Dell SC180 39 сторінок. Storage center
Також для Dell SC180: Посібник користувача (37 сторінок)
Друкувати сторінку
Electrical Safety Precautions
Always follow electrical safety precautions to avoid injury and damage to Storage Center equipment.
WARNING: Disconnect power from the expansion enclosure when removing or installing
components that are not hot-swappable. When disconnecting power, first power down the
storage system using the Dell Storage Client and then unplug the power cords from the power
supplies in the storage system and expansion enclosure.
•
Provide a suitable power source with electrical overload protection. All Storage Center components
must be grounded before applying power. Make sure that there is a safe electrical earth connection to
power supply cords. Check the grounding before applying power.
•
The plugs on the power supply cords are used as the main disconnect device. Make sure that the
socket outlets are located near the equipment and are easily accessible.
•
Know the locations of the equipment power switches and the room's emergency power-off switch,
disconnection switch, or electrical outlet.
•
Do not work alone when working with high-voltage components.
•
Use rubber mats specifically designed as electrical insulators.
•
Do not remove covers from the power supply unit. Disconnect the power connection before
removing a power supply from the expansion enclosure.
•
Do not remove a faulty power supply unless you have a replacement model of the correct type ready
for insertion. A faulty power supply must be replaced with a fully operational module power supply
within 24 hours.
•
Unplug the expansion enclosure chassis before you move it or if you think it has become damaged in
any way. When powered by multiple AC sources, disconnect all supply power for complete isolation.
Electrostatic Discharge Precautions
Always follow electrostatic discharge (ESD) precautions to avoid injury and damage to Storage Center
equipment.
Electrostatic discharge (ESD) is generated by two objects with different electrical charges coming into
contact with each other. The resulting electrical discharge can damage electronic components and
printed circuit boards. Follow these guidelines to protect your equipment from ESD:
•
Dell recommends that you always use a static mat and static strap while working on components in
the interior of the expansion enclosure chassis.
•
Observe all conventional ESD precautions when handling plug-in modules and components.
•
Use a suitable ESD wrist or ankle strap.
•
Avoid contact with backplane components and module connectors.
•
Keep all components and printed circuit boards (PCBs) in their antistatic bags until ready for use.
General Safety Precautions
Always follow general safety precautions to avoid injury and damage to Storage Center equipment.
•
Keep the area around the expansion enclosure chassis clean and free of clutter.
•
Place any system components that have been removed away from the expansion enclosure chassis or
on a table so that they are not in the way of foot traffic.
•
While working on the expansion enclosure chassis, do not wear loose clothing such as neckties and
unbuttoned shirt sleeves, which can come into contact with electrical circuits or be pulled into a
cooling fan.
16
Replacing SC180 Expansion Enclosure Components