Dell EMC N3200-ON Series Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Dell EMC N3200-ON Series. Dell EMC N3200-ON Series 10 сторінок. Powerswitch; external power supply installation
Також для Dell EMC N3200-ON Series: Посібник з монтажу (10 сторінок)
Друкувати сторінку
MPS-1S wall mount
Use the four wall-mount brackets to attach an external power supply (EPS) to the wall.
NOTE:
Do not wall mount the EPS with the front panel/PSU facing up or down.
You need a drill and a pencil to complete this procedure. This procedure applies to one EPS.
1. Remove the wall-mount brackets, wall anchors, and screws from the shipping bag.
This procedure uses four wall mount anchors, four M5 screws (length 16 mm), and eight M4 screws (length 6.8 mm).
2. Screw two brackets to the left side of the EPS using the M4 screws (length 6.8 mm) for each bracket, as shown.
Torque the screws to 10 in-lbs.
3. Repeat to attach two brackets to the right side of the EPS, as shown.
4. Hold the EPS or wall-mount template to the wall and mark the screw-hole locations on the wall with the pencil.
Wall mount locations for MPS-1S are approximately 8.37 in x 6.76 in (212.60 mm x 171.85 mm) (L x W).
8
N-Series EPS installation