Dell Force10 S4810 Посібник з конфігурації - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Перемикач Dell Force10 S4810. Dell Force10 S4810 17 сторінок. Dell force10 s4810 switch
Також для Dell Force10 S4810: Посібник із швидкого старту (27 сторінок), Посібник з розгортання (36 сторінок), Посібник з конфігурації (17 сторінок)

Dell recommended switch configuration

These steps show you how to configure two Force10 S4810 switches with a LAG. The switches are

interconnected using two of the 40 GbE Quad Small Form-factor Pluggable (QSFP) uplink ports, and the

LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).

2.1

Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using Putty or another terminal utility, open a serial connection session to the switch.

4. Open your terminal emulator and configure it to use the serial port (usually COM1 but this may vary

depending on your system). Configure serial communications for 9600,N,8,1 and no flow control.

5. Connect the (QSFP) LAG cables between the switches, by connecting port 48 on switch 1 to port 48

on switch2 and port 52 on switch 1 to port 52 on switch 2. See this configuration in Figure 1.

2.2

FTOS>enable

FTOS#delete startup-config

Proceed to delete startup-config [confirm yes/no]yes

FTOS#reload

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

2.3

FTOS>enable

FTOS>#config

FTOS(conf)#interface ManagementEthernet 0/0

FTOS(conf-if-ma-0/0)#no shutdown

FTOS(conf-if-ma-0/0)#ip address ipaddress mask

FTOS(conf-if-ma-0/0)#exit

SCG1000

Force10 S4810 Configuration Guide