Dell Force10 S60 Series Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Перемикач Dell Force10 S60 Series. Dell Force10 S60 Series 45 сторінок.
Також для Dell Force10 S60 Series: Посібник із швидкого старту (29 сторінок)

Друкувати сторінку

Features

The S60 offers the following:

• S60 CPU and switch processor

• Up to 12 stacked systems

• Stackable switch features

• 19-inch rack-mountable

• Standard 1U chassis height

• Hot-swappable optional modules, PSUs, and fan modules

• Integrated PSU/fan module (three fans per module)

• Up to 16K MAC address entries supported with hardware-assisted aging

• Supports 9K jumbo frames

Ports

• Optional ports supporting two 2-port, 10G SFP+ modules

• 44 fixed 10/100/1000 Mbps auto-sensing and auto-MDIX RJ45 ports

• Four fixed ports supporting 100/1000 Base-T or 1000 Base-X using auto-media detection

• Optional ports supporting one 2-port, 24G stacking module or two 1-port, 12G stacking modules

• Console port

• Universal Serial Bus (USB)-A port

• USB-B port

System Status

You can view S60 status information in several ways, including physical displays and boot menu options.

You can also view status information through the Command Line Interface (CLI) show commands and

with Simple Network Management Protocol (SNMP) traps. For more information about these options,

refer to the FTOS Command Line Reference Guide for the S60 System and the FTOS Configuration Guide

for the S60 System.

LED Displays

As shown in

Figure

2-3, the S60 rear panel contains several sets of Light Emitting Diodes (LEDs). The

Stacking ID is at the top right corner on the rear of the system and is shown in hexidecimal form. A small

decimal at the bottom right of the LED indicates the stack master.

NOTE: The stacking LED display is not applicable to the first release of the S60 system.

The S60 System