Dell N1148T-ON Посібник для початківців - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник для початківців для Перемикач Dell N1148T-ON. Dell N1148T-ON 27 сторінок.

Initial Configuration Procedure

Perform the initial configuration by using the Dell Easy Setup Wizard or by

using the CLI. The wizard automatically starts when the switch configuration

file is empty. Exit the wizard at any point by entering [ctrl+z], but all

configuration settings specified will be discarded, and the switch will use the

default values.

NOTE:

If you do not run the Dell Easy Setup Wizard or do not respond to the initial

Easy Setup Wizard prompt within 60 seconds, the switch enters CLI mode. You must

reset the switch with an empty startup configuration in order to rerun the Dell Easy

Setup Wizard.

For more information about performing the initial configuration by using the

CLI, refer to the CLI Reference Guide. This Getting Started Guide shows how

to use the Dell Easy Setup Wizard for initial switch configuration. The wizard

sets up the following configuration on the switch:

•

Establishes the initial privileged user account with a valid password. The

wizard configures one privileged user account during the setup.

•

Enables CLI login and HTTP access to use the local authentication setting

only.

•

Sets up the IP address for the VLAN 1 routing interface, of which all

in-band ports are members.

•

Sets up the SNMP community string to be used by the SNMP manager at

a given IP address. Skip this step if SNMP management is not used for this

switch.

•

Allows you to specify the network management system IP address or

permit management access from all IP addresses.

•

Configures the default gateway IP address for the VLAN 1 interface.

Getting Started Guide