Dell Networking S5000 Посібник з монтажу - Сторінка 39

Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Dell Networking S5000. Dell Networking S5000 50 сторінок. Data center switch
Також для Dell Networking S5000: Посібник з конфігурації (12 сторінок), Посібник з конфігурації (17 сторінок), Посібник для початківців (37 сторінок)

•

Stacking ports are divided into 16 stack-groups (0 to 15). Each set of four 10GbE ports on an Ethernet module or

each fixed 40GbE port on the front panel correspond to a stack group. Each stack group has 40GbE of

bandwidth. When a stack-group number is assigned, the ports associated with that group are configured as

stacking ports.

–

stack-group 0 = ports 0–3, stack-group 1 = ports 4–7, stack-group 2 = ports 8–11, and so on through

stack-group 11 = ports 44–47.

–

stack-group 12 = port 48, stack-group 13 = port 52, stack-group 14 = port 56, stack-group 15 = port 60.

•

All the ports in a stack-group are placed in stacking mode. You cannot use the unused ports in that group as

data ports.

Figure 23. Stack-Group Assignments

You can connect the systems while they are powered down or up. Stacking ports are bidirectional. The S5000 supports

stacking in either a ring or a daisy-chain topology. To provide redundant connectivity, Dell Networking recommends

using the ring topology when stacking S5000 systems.

Figure 24. Stacking Topology