Dell Networking S6000 System Посібник для початківців - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник для початківців для Перемикач Dell Networking S6000 System. Dell Networking S6000 System 37 сторінок. Dell networking s6000 high-performance 10/40 gbe top-of-rack switch
Також для Dell Networking S6000 System: Звіт про випробування (19 сторінок)
Друкувати сторінку
Installing an AC or DC Power Supply
To install an AC or DC power supply, follow these steps.
NOTE: The PSU slides into the slot smoothly. Do not force the PSU into a slot as
this may damage the PSU or the S6000 chassis.
NOTE: Ensure that the PSU is correctly installed. When the PSU is correctly
installed, the power connector is on the left side of the PSU and the status LED is at
the bottom of the PSU.
NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell
Networking recommends using power supply 1 (PSU1) as the blank plate slot.
Step
Task
Remove the PSU slot cover from the S6000 (the PSU side of switch). You may
1
select either of the two PSU slots.
Remove the PSU from the electro-static bag.
2
Insert the PSU into the switch PSU slot (insert the PSU exposed PCB edge
3
connector first).
The PSU slot is keyed such that the PSU can only be fully inserted in one
orientation.
1 - Slot 1
2 - PSU1
When the PSU is installed correctly, it snaps into place and is flushed with the
back of the switch.
14
Installation