Dell PowerConnect 2016 Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Перемикач Dell PowerConnect 2016. Dell PowerConnect 2016 46 сторінок. Unmanaged switches
Також для Dell PowerConnect 2016: Інформаційний посібник про систему (33 сторінок)
Друкувати сторінку
FILE LOCATION: C:\A-2003 Working Folder\All PowerConnect\E-Doc Posts\Eng UG rev\7H905ch.fm
NOTE: For racks that
are not pre-threaded,
cage nuts are provided.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 6 / 3 / 0 3
16
Ov er v ie w
Installing on a Flat Surface
The switch can be installed on any appropriate level surface that can safely
support the weight of the hubs and their attached cables. There must be
adequate space around the switch for ventilation and access cable
connectors.
To install the switch on a flat surface, complete the following steps:
Set the switch on the flat surface and check for proper ventilation.
1
Allow at least 2 inches (5.1 cm) on each side for proper ventilation and
5 inches (12.7 cm) at the back for power cord clearance.
Attach rubber feet on each marked location on the bottom of the
2
chassis.
The rubber feet are optional but recommended to keep the unit from
slipping.
Installing in a Rack
The switch can be installed in most standard 19-inch racks.
To install the switch in a rack, complete the following steps:
Use the supplied screws to attach a mounting bracket to each side of
1
the switch.
Position the switch in the rack and align the holes in the mounting
2
bracket with the holes in the rack.
Insert and tighten two screws appropriate for your rack through each of
3
the mounting brackets.