Dell PowerConnect 2624 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Перемикач Dell PowerConnect 2624. Dell PowerConnect 2624 21 сторінка. Powerconnect 26 series
Також для Dell PowerConnect 2624: Посібник користувача (38 сторінок)
Друкувати сторінку
NOTE:
Do not install rubber feet on the switch if you are rackmounting the switch.
To install the switch in a rack, complete the following steps:
1. Use the supplied screws to attach a mounting bracket to each side of the switch (see Figure 1-5).
Figure 1-5. Brackets for Rack Installation
2. Install the cage nuts onto the mounting rails of your rack, if your rack requires them.
NOTE:
Additional screws are provided for racks that have threaded mounting holes.
3. Position the switch in the rack and align the holes in the mounting bracket with the holes in the rack.
4. Insert and tighten two screws appropriate for your rack through each of the mounting brackets.
Installing the Switch on a Wall
To mount the switch on a wall, complete the following steps:
1. Ensure that the mounting point meets the following requirements:
The wall surface must be capable of supporting the switch.
l
Allow at least 5.1 cm (2 inches) on each side for proper ventilation and 12.7 cm (5 inches) at the back for power cable clearance.
l
The location must not be located in direct sunlight.
l
The location must not be within 2 feet of any heating vents, nor should any area heating vent point toward the unit.
l
The location must be ventilated to prevent heat buildup.
l
Do not locate the switch where there may be data or electrical cabling located directly behind the unit.
l
The power cable must reach an outlet.
l
2. Use the supplied screws to attach a mounting bracket to each side of the switch (see Figure 1-6).
Figure 1-6. Brackets for Wall Installation
3. Place the switch against the wall and mark the wall through the holes of the brackets.
4. Drill holes in the wall for the brackets and install the appropriate mounting hardware (not supplied).