Allied Telesis AT-AR023 SYN Посібник зі швидкого встановлення - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Мережева карта Allied Telesis AT-AR023 SYN. Allied Telesis AT-AR023 SYN 10 сторінок. Port interface card
Також для Allied Telesis AT-AR023 SYN: Посібник з монтажу (13 сторінок), Посібник з монтажу (13 сторінок), Технічний паспорт (1 сторінок), Посібник з монтажу та техніки безпеки (8 сторінок)

For more information on PIC jumpers and hardware configurations, see

the Port Interface Card Hardware Reference. This Reference can be found on

the CD-ROM bundled with recently purchased switches or routers, or can

be downloaded from www.alliedtelesyn.co.nz/support/support.html.

Do not attempt to change any jumpers, DIP switches, or other hardware

configurations while the switch or router is connected to a power supply,

redundant power supply, or a 'live' network. Dangerous voltages may be

present on some parts of the board, even if the switch or router is not turned on.

Slide the PIC into place

PIC bays should be filled in numerical order, starting with the lowest

available bay (e.g., bay 0) followed by bays with progressively higher

numbers.

When using AT-AR027 PICs with an AR740 router and NSM, a maximum of four

AT-AR027 PICs can be installed in the router and NSM.

10. Secure the PIC by tightening its thumbscrews

11. Apply power to the switch or router by re-attaching the power cord

12. If you disconnected a redundant power supply, reconnect it

13. Test the PIC

There are several ways to check the PIC is installed and functioning

correctly.

The SHOW SYSTEM command displays general system information about

PICs and any other hardware installed, as well as memory, software release

and patches loaded on the switch or router.

See the Port Interface Card Hardware Reference for detailed information on

PIC testing.

Port Interface Card

C613-04020-01 REV H