Dell PowerConnect 8024F Оновлення прошивки - Сторінка 6

Переглянути онлайн або завантажити pdf Оновлення прошивки для Перемикач Dell PowerConnect 8024F. Dell PowerConnect 8024F 24 сторінки. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Також для Dell PowerConnect 8024F: Примітки до випуску (27 сторінок), Примітки до випуску (20 сторінок), Посібник з конфігурації (21 сторінок), Посібник з впровадження (8 сторінок)

Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or

4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware

3. Download the 5.1.9.3 firmware to the switch or stack master. The following versions are available:

- PC7000_M6348v5.1.9.3.stk

- PC8024v5.1.9.3.stk

- PCM6220v5.1.9.3.stk

- PCM8024kv5.1.9.3.stk

4. Activate 5.1.9.3 firmware.

5. Update the boot code from the CLI after performing steps 1 through 4 above. If the "update bootcode"

command does not boot the switch automatically, reload the switch. The upgrade procedure will take

several minutes to complete for an individual switch and longer for a stack of switches.

NOTE:

After upgrading to the 5.1.9.3 firmware, one can emulate the earlier

firmware default behavior for privileged exec (enable) mode access by

setting the enable authentication method to enableList.

console(config)# line telnet

console(config)# enable authentication enableList

console(config)# exit

NOTE:

After upgrading the switch firmware version to 5.1.9.3, the CPLD

(Complex Programmable Logic Device) code update is required on M8024-k

and PC8024/PC8024F switches if switch is running with the older CPLD

version. CPLD update can be done only via switch serial console (not

through SSH or Telnet).

You can verify the running CPLD code version by executing the command

"console#dev cpldTest" from console. The latest CPLD version available for

M8024k and PC8024/PC8024F switch is Version 6.

Upgrade Example for Switches Running v3.x.x.x or v4.x.x.x or v5.x.x.x Firmware

This example shows an annotated upgrade example for a PC8024 switch running 4.2.1.3 firmware. Administrators

can also follow the same procedure to upgrade switches running 3.x.x.x or 5.x.x.x to 5.1.9.3 firmware. This example

presumes the administrator is logged in to the switch or stack via telnet or SSH. If following this example, be sure to

use the firmware appropriate to the switch being upgraded and TFTP server is accessible from the switch.

1. Back up your configuration. The following commands copy the running-config to a TFTP server:

console#copy running-config tftp://10.10.10.200/myconfig.txt

Mode........................................... TFTP

Set TFTP Server IP............................. 10.10.10.200

TFTP Path...................................... ./

TFTP Filename.................................. myconfig.txt

Data Type...................................... Config Script

Source Filename................................ running-config

Management access will be blocked for the duration of the transfer

Are you sure you want to start? (y/n) y

11062 bytes transferred

File transfer operation completed successfully.

Page 3