Dell PowerConnect M8024-k Посібник з конфігурації - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з конфігурації для Перемикач Dell PowerConnect M8024-k. Dell PowerConnect M8024-k 21 сторінка. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Також для Dell PowerConnect M8024-k: Примітки до випуску (27 сторінок), Оновлення прошивки (24 сторінок)
Друкувати сторінку
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
3.14
Configure SFP+ ports for LAG (M8024)
Note: The commands in this section assign four 10Gb SFP+ ports from an optional expansion module in
the first expansion slot, to the Port Channel. If you have the M8024-k switch, see section 3.13 instead.
console(conf)#interface range tengigabitethernet 1/1/1-4
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
3.15
Save configuration
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
3.16
Configure additional switch
Repeat the commands from section 3 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the documentation for your switch.
14
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs