Dell PowerConnect M8428-k Посібник - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник для Перемикач Dell PowerConnect M8428-k. Dell PowerConnect M8428-k 25 сторінок. Dell poweredge m710 and m710hd - system memory update
Також для Dell PowerConnect M8428-k: Посібник з оновлення (32 сторінок), Примітки до випуску (27 сторінок), Посібник користувача (23 сторінок), Посібник з оновлення (1 сторінок)
Rev 1.00
Description:
Use this command to restart the module components. When this command is issued, PTM compo-
nents go through a full hardware reset, followed by software reload.
Options:
• device_number: specify a single device to reset
Example:
$ reload
3.5
Software Update Commands
3.5.1 show image ver
Synopsys:
show image ver
Description:
Display the current software image version.
ADMIN: This command also displays the firmware version of each component.
Example:
# login admin
& show image ver
Software image short version: V Z.ZZ
Software image version: X.X.XXX-<date stamp>
Component #1 firmware version: Y.Y.YYY
Component #2 firmware version: Y.Y.YYY
Component #3 firmware version: Y.Y.YYY
& login user
3.5.2 copy image from-file
Synopsys:
copy image from-file [device_number]
Description:
Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a
single device in the PTM. Immediately after running this command, the CLI waits for the user to
send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For
additional details on the firmware update procedure refer to
on page 22
.
ADMIN:
16
Section 4, "Operating Procedures,"
Software User's Manual