Dell S4248FB-ON Посібник з монтажу - Сторінка 40

Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Dell S4248FB-ON. Dell S4248FB-ON 47 сторінок. S4200-on series
Також для Dell S4248FB-ON: Посібник з налаштування (29 сторінок)

Друкувати сторінку

1. Features

You can install an operating system manually from HTTP, FTP, or TFTP using the onie-nos-install <URL> command.

NOTE:

If you have a recovery USB plugged into your switch, remove it before installing the DIAG-OS using the onie-nos-

install command.

The ONIE Install environment uses DHCP to assign an IP address to the management interface—eth0. If that fails, it uses the default IP

address 192.168.3.10/255.255.255.0.

To display the IP address, use the ifconfig eth0 command, as shown in the following example.

ONIE:/ # ifconfig eth0

eth0 Link encap:Ethernet HWaddr 90:B1:1C:F4:9C:76

inet addr:10.11.53.33 Bcast:10.255.255.255 Mask:255.0.0.0

inet6 addr: fe80::92b1:1cff:fef4:9c76/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:18 errors:0 dropped:0 overruns:0 frame:0

TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000

RX bytes:1152 (1.1 KiB) TX bytes:6864 (6.7 KiB)

Interrupt:21 Memory:ff300000-ff320000

To assign an IP address to the management interface, eth0, and verify network connectivity, use the ifconfig eth0 <ip address>

command, as shown in the following example:

ONIE:/ # ifconfig eth0 10.11.53.33/16

Verify the network connection with ping.

ONIE:/ # ping 10.11.8.12

PING 10.11.8.12 (10.11.8.12): 56 data bytes

64 bytes from 10.11.8.12: seq=0 ttl=62 time=1.357 ms

64 bytes from 10.11.8.12: seq=1 ttl=62 time=0.577 ms

Management ports