EarthQuake AWS-602 Посібник користувача та гарантія - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача та гарантія для Спікери EarthQuake AWS-602. EarthQuake AWS-602 6 сторінок. Aws series all weather speakers
Також для EarthQuake AWS-602: Посібник користувача (6 сторінок)

Друкувати сторінку

EarthQuake AWS-602 Посібник користувача та гарантія

Installation

How to Wire the AWS Speakers

In order to achieve the best quality and stereo imaging from your AWS

speakers, you must wire the speakers correctly. Wiring can be quickly and

easily achieved, but be aware and cautious of your work, wiring incorrectly can

result in poor sound stage and bass reproduction. 18-gauge (or heavier)

speaker cables are recommended for lengths ranging from 25 feet and up. Prep

your cable for installation: strip the ends 1/2" (12mm) to expose wire, and tightly

twist the ends. For installations that are run on or through a building, use the

correct weather proofed wire that complies with local codes.

WARNING

Prevent electrical shock, by switching off the ampliﬁer or receiver when making

connections to the speaker. When making all connections, be sure to connect

the + (positive) on the speaker to the + (positive) on the ampliﬁer, and the -

(negative) on the speaker to the - (negative) on the ampliﬁer.

-(negative)

IMPORTANT:

Speaker wire is

usually marked or textured

differently to distinguish between

positive and negative.

Using the gold-plated binding

posts: you can easily connect

banana-plugs, spade-plugs and

bare wire. Insert the wire into the

hole tighten securely (do not let

bare wire hang out side of hole).

Installation

Connecting to an Ampliﬁer or Receiver

1) Connect the speaker terminals to the ampliﬁer speaker outputs.

2) When making all connections, be sure to connect +(positive) to +(positive)

and - (negative) to -(negative).

- +

Ampliﬁer / Receiver

Verify That You Correctly Connected Your Speakers

It is important that your speakers are hooked up with alike polarity or "in-phase".

Use this easy test to determine if you have connected your speakers correctly.

Place speakers face-to-face, as close together as possible. Set your ampliﬁer to

mono and begin listening to music, reverse the connections on one of the

speakers. You should hear distinguishable change in sound. The speaker that

plays louder and deeper is the one that is connected correctly.