EarthQuake MiniMe P12 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Сабвуфер EarthQuake MiniMe P12. EarthQuake MiniMe P12 16 сторінок. Earthquake sound subwoofers user's manual
Друкувати сторінку
(6) Auto ON/OFF
When the main "POWER" ON/OFF switch is in the
"OFF" position, this switch has no affect on the
subwoofer. When the main "POWER ON/OFF" switch
is in the "ON" position, this switch allows the auto
circuit to be engaged. When this switch is in the
"AUTO" position, the subwoofer will automatically turn
"on" when it senses a signal. It will automatically turn
"off" after 20 minutes with no signal. When this switch
is in the "ON" position, the subwoofer will remain on
as long as the "POWER" ON/OFF switch is in the
"ON" position.
(7) 110-120V AC Power Connection
The Earthquake MiniMe is equipped with a built in
standard, two-prong power connection.
(8) Power Status LED
Earthquake powered subwoofers have an LED on the
panel that indicates the status of the built-in amplifier.
The LED will light red when the amplifier is in standby
mode and green when the amplifier is on and
receiving a signal.
(9) 0-180° Phase Shift
This control is used to acoustically match the
subwoofer's output to your main speakers. Select the
position, either 0° or 180°, in which your subwoofer
has more output at the listening position.
Earthquake • MiniMe User Manual
Control Panel Overview Continued
6
(10) Sub Operation Switch
In LFE position, the Frequency adjustment becomes
disabled and the subwoofer runs in a Full range
mode, from 20Hz - 2kHz.
While in Sub position the subwoofer reverts to the
manual frequency adjustment, allowing the user to
operate and fine tune the subwoofer to their personal
taste.
(11) 50Hz - 160Hz Frequency Adjustment
This controls the high frequency cutoff point. With the
control set to the middle, the subwoofer will reproduce
frequencies up to 105Hz. If the control is set fully
clockwise, the crossover is bypassed and the
subwoofer will reproduce a wide frequency range.
With the control fully counter-closkcwise the
subwoofer reproduces a narrow range, up to 50Hz.
Rotate the control until the bass sound natural. If the
mid-bass sounds natural but you want more low bass,
turn the control down a little.
(12) Volume Control
Manual volume control to regulate your subwoofers
power output, to prevent clipping and distortions
caused by overpowering.
Always unplug the power cord before
inspecting or changing the fuse. Never
use a fuse with a larger current rating
than recommended.