AVZ Twins Piazzola Інструкція з монтажу - Сторінка 17

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Аксесуари AVZ Twins Piazzola. AVZ Twins Piazzola 20 сторінок. Gastro awning

Assembly instructions Twins

37. Slide the central pulley towards the middle of the bottom profile.

38. Pull out the cord leading through the guide block, lead it through the side guide and lay it over the

wheel of the end bearing. Ensure that the cord is not crossed in the side guide.

Pull the cord through the guide block and roll it

39. Lead the cord through the bottom front profile as shown in the figure below.

40. Check that the cord runs neatly over all the pulley wheels. Tension the spring by pulling the cord in

the cord tensioners and position the cord around the wheel behind the cord tensioner.

Note: Every spring may be drawn to a maximum of 60% of its own length.

41. Fasten the cord using the enclosed wheels and self-drilling screws, as shown in the figure below.

42. Let the awning run in and out a couple of times to check the correct functioning.

43. Straighten the top cover by turning the socket head screw at the back of the bottom cover.

44. Hook the cover into the top of the front profile and click to fasten.

45. Use the hexagonal nut to tension the front profile.

Piazzola

Butterfly awning

500 mm from the middle

Never extend the springs more than 60% of their own length

Fasten the cord using encl. wheels and self-drilling screws

Twins Piazzola EN 27-08-2018

Middle of front profile

Page 17