EarthQuake PH2000W/D1 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач EarthQuake PH2000W/D1. EarthQuake PH2000W/D1 10 сторінок. Powerhouse series amplifiers
Також для EarthQuake PH2000W/D1: Брошура (8 сторінок), Посібник користувача (11 сторінок), Посібник користувача (10 сторінок)

EarthQuake PH2000W/D1 Посібник користувача

PH1000W/2

+18dB boost @ 45Hz
+12dB boost @
designed to shape/
12kHz essential
boost the response
boost for high-pass
curve in a low-pass
amplifier applications
mode application.
SPEAKER
CH1
CH2
MONO
S p e a k e r O u t p u t s
Minimum 4 Ohm Mono
8
Specifications Are Subject To Change Without Notice
3-way switch
RCA level inputs, with
runs the amp
a range of 0.2V to 5V.
in low-pass,
RMS.
full-range or
high-pass
3-way switch feeds RCA
mode.
outputs a low-pass full-
range or high pass signal.
Crossed RCA level
outputs, can be used
to feed other amplifiers
in the system.
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
BAT
REM GND
FUSE
POWER
Born In The USA
To car chassis / ground
30A Fuse
To remote turn on / trigger
To battery (+)
The PH1000W/2 is designed to
operate in stereo or mono mode. When
used in stereo applications, a minimum
load of 2 ohms per channel is required.
Set Xover knob to
Minimum (20Hz), &
set Xover switch to
Full Range
FC6.2
FC6.2
Tweeter
Tweeter
FC6.2 Midrange
FC6.2 Midrange
The PH1000W/2 is designed to
operate in mono mode. When
bridging the two channels, a
minimum load of 4-ohms is
required.
www.earthquakesound.com
9