EarthQuake E43 earth auger powerhead Посібник оператора - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник оператора для Газонна та садова техніка EarthQuake E43 earth auger powerhead. EarthQuake E43 earth auger powerhead 16 сторінок. Power earth auger
Також для EarthQuake E43 earth auger powerhead: Посібник оператора (17 сторінок)

Друкувати сторінку

EarthQuake E43 earth auger powerhead Посібник оператора

TROUBLESHOO

TROUBLESHOOTING

TROUBLESHOO

TING

Problem

Engine will not start

Engine runs rough, floods during opera-

tion

Engine is hard to start

Engine misses or lacks power

Auger turns at idle

Auger turns, but has no power

Auger jumps

Auger cuts slowly

Engine runs, then quits

Engine revs too high

1-800-345-6007

SERVICE

SERVICE, TROUBLESHOO

, TROUBLESHOO

, TROUBLESHOOTING AND REP

SERVICE

, TROUBLESHOO

Practice safety at all times. Engine must be turned off

and allowed to cool, and spark plug wire must be

disconnected before attempting any maintenance or

repair.

Possible cause

1. Power switch off

2. Spark plug wire disconnected

1. Dirty air cleaner

2. Choke partially engaged

3. Carburetor out of adjustment

1. Stale fuel

2. Spark plug wire loose

3. Dirty carburetor

1. Clogged fuel tank

2. Clogged air cleaner

3. Improper carburetor adjustment

4. Spark plug dirty, improper gap, or

wrong type

1. Idle speed too high

2. Broken clutch spring

1. Choke on

2. Carburetor out of adjustment

3. Broken transmission

4. Worn clutch shoes

5. Worn engine lower seal

1. Blades damaged

1. Dull blades

2. Damaged fishtail point

1. Gas cap not venting

1. Low fuel in tank

TING AND REP

TING AND REPAIR

TING AND REP

CAUTION

Page 11

AIR

Remedy/Action

1. Flip switch to on position

2. Connect spark plug wire to spark plug

1. Clean or replace air cleaner

2. Turn off choke

3. Call factory

1. Drain old fuel and replace with fresh.

Use gas stabilizer at end of season

2. Make sure spark wire is securely

attached to spark plug

3. Clean carburetor, use gas stabilizer,

new gas can

1. Remove and clean

2. Clean or replace

3. Call factory

4. Replace spark plug and adjust gap

1. Adjust idle speed lower

2. Replace both springs

1. Turn off choke after engine is running

2. Call factory

3. Call factory

4. Replace clutch shoes and springs

5. Call factory

1. Install new blades

1. Replace blades

2. Replace fishtail point

1. Check self venting gas cap

1. Add fuel to tank