360 BANDIT HARVEST INTERNATIONAL Інструкція з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Сільськогосподарське обладнання 360 BANDIT HARVEST INTERNATIONAL. 360 BANDIT HARVEST INTERNATIONAL 4 сторінки.
Друкувати сторінкуINSTALLATION INSTRUCTIONS
HARVEST INTERNATIONAL
STEP 3
INSTALL ROCK GUARD
6
Insert one of the longer 1/2" bolts 6 through the rock
guard 7 and then through the front hole on the closing
system plate. Secure to the BANDIT unit.
Insert the second 1/2" bolt through the rear hole of the
closing system plate 8 and secure to the BANDIT unit.
Tighten both using 3/4" wrench and socket.
STEP 4
PREPARE HOSE GUIDES
9
8
CUT
7
7
11
Using side-cutters, cut the two hose guides apart 9.
Route the hose through the top two holes in the hose guide
.
10
Hose guides are labeled "L" left and "R" right
NOTE: When installing hoseguides on the row unit, left and
right are determined from the operators seat.
9
6
10
11
.
PAGE 3
STEP 5
INSTALL DISK ASSEMBLY
13
15
14
12
16
12
Insert 5/8" X 3" bolt
through the disk
12
shim washer then fender washer over the bolt. Insert
bushing
(large side first) and hose guide assembly
14
tab
facing in).
16
Slide bolt of the disk assembly into the lower hole on the
bandit
, aligning the ear tab
with corresponding upper
12
16
hole and secure with lock nut.
Tighten with 15/16" socket and wrench. Check to ensure
that the disk freely turns. If the disk does not freely turn,
back off the lock nut slightly until the disk freely turns.
Using a mallet, install provided dust caps over disk bolt
heads.
Route application hose through hole in top of 360 BANDIT
frame
.
17
Repeat for other side.
16
17
. Place small
13
(ear
15