EarthWay 2170T Посібник з монтажу та експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Розкидач EarthWay 2170T. EarthWay 2170T 6 сторінок. Commercial tow
broadcast spreader
Також для EarthWay 2170T: Посібник з монтажу та експлуатації (6 сторінок)
Друкувати сторінку
1/4 - 20
Lock Nut
Shut-Off
Rotate
Plate
Pivot
1/4 - 20
Lock Nut
Pivot Rod
with extra bend
1/4 X 1½"
Hex Head Bolt
1/4 X 2"
Hex Head Bolt
1/4 X 1½"
1/4 X 1¾"
Hex Head Bolt
Hex Head Bolt
1/4 X 2¼"
Hex Head Bolt
Hitch Extension
Mounting
1/4 - 20
Lock Nut
Hitch Plates
1/4 - 20
Lock Nut
7. Insert pivot rod into shut off plate as shown. Turn to lock in place.
8. Insert other end of pivot rod into pivot and bracket assembly as shown. Turn to lock in place.
9. Install Control Support between lower handles as shown inserting (2) 2" bolts thru the Pivot Bracket and the Lower Handles and secure
with (2) lock nuts. Next, line up the hole in the Cross Brace with the hole in the Control Support. Insert 1/4-20 X 2¼" bolt through the
Control Support and thru the hole in the Cross Brace, secure with a 1/4-20 lock nut. Now determine if you want to add the Hitch Extension
to the Control Support. If you do add the Extension, use the 1/4-20 x 1½" bolt & lock nut through the Hitch Extension tube and the Control
Support as shown above. And use the 1/4-20 X 1¾" bolt to install the Hitch Plates and secure with a 1/4-20 lock nut. If not used, secure the
Hitch Plates by using 1/4-20 x 1½" bolt and 1/4-20 lock nut through the Control Support and the Hitch Plate as shown above.
10. Attach Gauge & Lever assembly to Control Support using (2) 1/4-20 X 1½" bolts and (2) 1/4-20 lock nuts and T
.
ighTen
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
Coast Wheel
1" Cotter Pin
Gearbox &
Axle Assembly
Drive Wheel
2" Cotter Pin
Lower
Handle
Frame
Brace
Cross Brace
11. Slide axle bushing over axle and into axle bearing to both sides as shown.
12. Install drive wheel to axle using pin hole nearest to lower handles as shown.
Insert 2" cotter pin through wheel and through axle. Bend with pliers to prevent pin
from falling out.
13. Install coast wheel to axle using outside pin hole. As shown, insert 1" cotter pin
through axle (not thru the wheel). Bend with pliers to prevent pin from falling
out.
TURN SPREADER UPRIGHT ON TO WHEELS.
PAGE 3