EarthWay 2600A-Plus Estate Посібник з монтажу та експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Розкидач EarthWay 2600A-Plus Estate. EarthWay 2600A-Plus Estate 8 сторінок. Broadcast spreader
Також для EarthWay 2600A-Plus Estate: Інструкція з монтажу та експлуатації (5 сторінок)
Друкувати сторінку
Broadcast Setting Matrix
How to ensure your spreader is properly calibrated
Make sure the drop holes in the bottom of the hopper are fully open when the Rate Control handle is on #30. If not,
please adjust the control rod to allow for a full open hopper position at #30.
Rod Type Adjustment
Open the shut-off so that the drop holes are completely open as illustrated below.
Review the Control Lever position - if it is set so that the forward edge is at #30,
you are calibrated. If not, you need to adjust the control rod at the pivot bracket
shown in Fig 1.
If your shut-off is able to open fully as in step #1, but the Control Lever is not at
#30. Loosen #14 Nut, then slide the Control Rod (#12) in the Gauge & Linkage
Assembly (#8) so that it allows you to push the Control Lever to #30. Next tighten
#14 Nut. Recheck adjustment as outlined above.
If you have any questions regarding the operation or assembly of your spreader please call us at 800-294-0671 or
574-848-7491 Monday - Friday 9:00am - 4:00pm Eastern. Accessories and Repair Parts are also available at these
numbers.
Fig 1
Calibration Techniques
Control
Rod #12
Control Lever
at #30
#14
Nut
Gauge & Linkage
Drop holes shown fully open.
Assembly #8