EarthWay EV-N-Spred C22HDS Посібник з монтажу та експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Розкидач EarthWay EV-N-Spred C22HDS. EarthWay EV-N-Spred C22HDS 6 сторінок. Broadcast spreader
Також для EarthWay EV-N-Spred C22HDS: Посібник з монтажу та експлуатації (8 сторінок), Посібник з монтажу та експлуатації (6 сторінок)

Install impeller onto pinion shaft. Insert 1/8" x 1-1/4" cotter pin

through impeller then through pinion shaft. Use hole nearest gear box.

Spread cotter pin to prevent from falling out. Next, install the Cross Brace

through the Gearbox Brace as shown above.

Install Lower Handles onto Axle to both

sides as shown above. Now insert 1-1/2" bolt

through first hole in lower handle, then

through frame brace, and finally into the

threaded connector in the Cross Brace.

[NOTE: Dimples on frame braces must be

facing toward gearbox as shown.]

DO NOT TIGHTEN YET.

Next insert 1-1/2" bolt through other end of

frame brace and through second hole in frame

install locknut.

DO NOT TIGHTEN YET.

Now insert 2-1/4" bolt through second hole in

lower handle and through first hole in frame.

NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.

PAGE 2

Install Gearbox by inserting the pinion shaft into hole in center

of hoppers bottom. The word "FRONT" on the gearbox must

point to F

of the hopper.

RONT