Miele PW 6101 Інструкція з експлуатації Посібник з експлуатації - Сторінка 33

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Пральна машина Miele PW 6101. Miele PW 6101 46 сторінок. Profitronic m innovation m
Також для Miele PW 6101: Інструкція з експлуатації Посібник з експлуатації (44 сторінок), Інструкція з програмування (48 сторінок), Інструкція з програмування (48 сторінок)

Miele PW 6101 Інструкція з експлуатації Посібник з експлуатації
^ Tighten up the venting screw again and
check that there is no leak.
^ First position the screwdriver in the
opening, then push it in and hold it
securely.
Press against the door handle with your
right hand, and then pull on the door
handle to open the door.
Never use force to open the door!
^ Remove the laundry
Possible reasons for increased
levels of foaming
– Detergent type
^ Only use detergents formulated for
commercial washer-extractors. Domestic
laundry detergents are not suitable.
– Using too much detergent
^ Follow the manufacturer's dosage
recommendations on the packaging and
take local water hardness levels into
account.
– Heavy foaming detergent
^ Use a low foaming detergent or contact
your detergent supplier for advice.
M.-Nr. 06 533 412
Problem solving guide
– Very soft water
^ In areas with very soft water (hardness
level 1) dispense less detergent as
specified by the detergent manufacturer.
– Soiling level of the laundry
^ For lightly soiled laundry dispense less
detergent in accordance with the
detergent manufacturer's instructions.
– Residues e.g. detergent on the laundry
^ Run a pre-wash without detergent and
without selecting a temperature.
Laundry which has been soaked before
washing must be thoroughly rinsed before
running a wash programme.
– Small loads
^ Reduce the amount of detergent
dispensed according to the size of the
load.
– Drum speed too high during the wash
(Profitronic controls)
^ Reduce the drum speed and the wash
rhythm.
– Gas-heated washer-extractors
On gas heated machines the suds solution
is pumped around the heater elements. This
additional movement of the suds can
produce extra foam.
^ Follow the dispensing instructions given
above.
^ Use a low lather detergent.
^ On Profitronic controlled machines and in
special circumstances it is possible to
reduce the drum speed and the wash
rhythm during the heating-up phase.
33