Miele PW 6241 Інструкція з експлуатації Посібник з експлуатації - Сторінка 31

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Пральна машина Miele PW 6241. Miele PW 6241 46 сторінок.
Також для Miele PW 6241: Інструкція з експлуатації та монтажу (44 сторінок), Інструкція з експлуатації та монтажу (44 сторінок), Інструкція з програмування (48 сторінок)

Miele PW 6241 Інструкція з експлуатації Посібник з експлуатації
Service interval
If after switching the machine on the
following message appears in the display
the machine will need to be serviced by the
Miele Service Department.
Service interval 1
§
Call the Service Department
The display will go out after 5 minutes.

Error messages

,
Repairs to electrical, gas or steam
operated machines may only be carried
out by a suitably qualified person in
accordance with national and local safety
regulations. In the U.K. repairs to gas
heated machines must only be carried out
by a Gas Safe registered technician.
A message will appear in the display if there
is a problem either before starting a
programme or once it has started:
The display remains dark.
There is no power to the machine.
^ Check the mains switch and the on-site
fuses.
Power cut
y
Programme stop
Press the start button.
^ Once power has been restored press the
START button.
This error message can also indicate that
the winding on the motor has overheated.
^ Allow the motor to cool down.
M.-Nr. 06 572 495
Water inlet fault
M
Call the Service Department
if restart does not work.
i
^ Check the stopcock and then press the
START button.
A
Door lock fault
a
Call the Service Department
if restart does not work.
i
^ Push firmly on the door handle until you
hear the lock engaging. Confirm by
pressing START.
Heating system fault
§
Programme stopped. Press start.
Programme will continue without heat.
i
^ To continue the programme with heating
press the START button. If a disinfection
programme was running the programme
will be cancelled if this message appears.
Call the Service Department.
Drive motor fault
m
Programme stopped. Press the start button.
Motor overheating.
i
^ Allow the motor to cool down.
Imbalance fault
§
Call the Service Department
f
if restart does not work.
i
The imbalance is too great and the
imbalance switch has been activated.
^ Switch the machine off and on again. Then
press the START button.
Problem solving guide
f
f
f
f
A
31