Miele WS 5071 Інструкція з експлуатації Посібник з експлуатації - Сторінка 23

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Пральна машина Miele WS 5071. Miele WS 5071 36 сторінок. Washer-extractor

Друкувати сторінку

Liquid dispensing

Commissioning the dispensing pumps

Before the liquid dispensing pumps can be

used the liquid detergent must be drawn into

the system and the amount to be dispensed

set. The Service Programme is used for this.

Drawing in the liquid detergent

Insert the suction pipes into the liquid

detergent containers.

Service operation:

Switch off the washer extractor.

Operating mode B, set the programme se-

lector switch to 24.

Switch on the washer-extractor, and within

4 seconds, press the Block plus button T

4 times in quick succession. This brings

you into Service operation. The cursor is

already at the Service programmes.

SERVICE - OPERATION

>SERVICE PROGRAMMES<

After selection press Start button.

Press the Start button X .

SERVICE - OPERATION

SERVICE PROGRAMME >1<

After selection press Start button.

Select SERVICE PROGRAMME 2 with

the Plus button 4 and press the Start but-

ton X .

SERVICE - OPERATION

SERVICE PROGRAMME 2

Dispenser valve >D1<

After selection press Start button.

With the Plus button 4 select D1, with the

Cursor button 2 move to the input field for

dispensing time and with the Plus button

4 set a dispensing time of approx. 20 sec-

onds. Press the Start button X, and the

hoses of pump 1 will be filled.

MACHINE DATA

SERVICE PROGS

SERVICEPROGS

Disp. time 0 Secs.

SERVICE - OPERATION

SERVICE PROGRAMME 2

Dispenser valve >D1<

Cancel with the End button.

Cancel with the End button 7.

Repeat the whole process with other pumps

(D2 and D3).

SERVICE - OPERATION

>SERVICE PROGRAMMES<

After selection press Start button.

Press the Start button, select the SER-

VICE PROGRAMME 2, and press the

Start button X .

To exit from Service operation:

Cancel with the End button 7 and switch

off the machine.

Switch the machine on and select Pro-

gramme 8 , SEPARATE RINSE and SPIN,

to flush the proofing agent out of the ma-

chine.

To correct the amount dispensed by the

pumps (should the dispensing times set not

be enough)

The amount to be dispensed is measured out

in litres in the Service programme. The proce-

dure is similar to the one for drawing up the

liquid detergent. The dispensing time de-

cided on is then set in the operating mode C

Programming in the step programming.

The maximum pump throughput is ap-

prox.168 ml/min. for all pumps.

These figures are only intended as a guide,

and will vary according to the medium.

Put the suction pipe into a deep measur-

ing container with sufficient liquid deter-

gent and keep it at the full level.

Continue as for Drawing in liquid detergent

SERVICE PROGS

Disp. time 20 Secs.

MACHINE DATA

M.-Nr. 05616270