Allmand MAXI LITE II Посібник із швидкого старту - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Промислове обладнання Allmand MAXI LITE II. Allmand MAXI LITE II 17 сторінок.

SERIAL NUMBER 10-000001 & 11-000001

Testing Ballast & Generator Capacitors.

WARNING: Dangerous voltage and/or current may be present when a

voltage test is being conducted. To reduce risk of serious injury or death from electrical

shock, if you are not trained to safely work with high voltage, do not attempt any of these

procedures. You must seek assistance from qualified personnel.

Disconnect both capacitor leads

Using a screwdriver or similar instrument with an insulated handle, short the capacitor

between the terminals to discharge any stored power (Figure B.1). The capacitor may

be freely handled after it has been discharged.

Select O hms o n your multimeter to t he highest setting.

Check the resistance between the capacitor terminals (Figure R.1).

A. If the meter shows a low resistance reading which gradually increases, the

capacitor is likely good and does not need to be replaced.

B. If the meter shows a very high resistance that remains steady, the capacitor is

open and must be replaced.

C. If the meter indicates a very low resistance that remains steady, the capacitor is

shorted and must be replaced.

MAXI LITE II