360 Yield 360 Y-DROP CASE 80 BOOM Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сільськогосподарське обладнання 360 Yield 360 Y-DROP CASE 80 BOOM. 360 Yield 360 Y-DROP CASE 80 BOOM 11 сторінок.

Друкувати сторінку

INSTALL MOUNT ASSEMBLIES

II.

ON THE OEM PRIMARY BOOM

NOTE: It is only on the 120' booms that the center

section wet boom is below the OEM boom. On the

80' , 90' and 100' booms, the wet boom is positioned

higher. Keep this is mind, as the pictures that follow

may not exactly match your equipment. This will not

affect the installation of the 360 Y-DROP brackets.

Figure 4

Step 1

With the threads pointing down, install

U-bolt (1) on the top of the OEM primary

boom.

Primary Booms:

Rogator 80, 90, 100 - Use Bag AD and Bag AJ

Rogator 120 - Use Bag AD

Step 2

Install bracket assembly (2) and flange

lock nut (3).

Hardware Kit D

Repeat Steps 1 and 2 for the other OEM mount

bracket kit.

Step 3

Install extension tube (4).

Step 4

Install boom bracket (5) onto the

extension tube.

Step 5

Install square U-bolts (6), the 5/16" extra

thick washers and the 5/16" nuts.

Hardware Kit A

Step 6

Install stop bolts (7) at both the front

and the rear of the extension tube.

Hardware Kit B

Figure 5

Step 7

Install stainless steel set screw and jam nut

assembly (1) onto the bracket assemblies.

Hardware Kit D

Repeat Steps 1-7 for the remaining mount

assemblies on the OEM primary boom.

INSTRUCTIONS 360 Y-DROP

Figure 4

Figure 5

360YIELDCENTER.COM

ROGATOR