Miele AWG 102 Інструкція з монтажу Посібник з монтажу - Сторінка 20

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вентиляційна витяжка Miele AWG 102. Miele AWG 102 28 сторінок. External motor roof installation
Також для Miele AWG 102: Посібник з експлуатації та встановлення (24 сторінок), Інструкція з експлуатації та монтажу (28 сторінок), Інструкція з монтажу Посібник з монтажу (28 сторінок)

Connection for air extraction

 Only use smooth pipes or flexible

hoses made from non-flammable

materials for the extraction ducting.

 To achieve the greatest possible air

extraction with the lowest noise level,

please note the following:

– The cross-section of the exhaust

ducting must not be smaller than the

cross-section of the exhaust

connection (see "Appliance

dimensions").

– The exhaust ducting should be as

short and straight as possible.

– Only use wide radius bends.

– The exhaust ducting should not be

kinked or compressed.

– Ensure that all connections are

strong and airtight.

Remember that any constriction of

the airflow will reduce extraction

performance and increase operating

noise.

 If the exhaust air is to be ducted into

a vent flue, the ducting must be

directed in the flow direction of the

flue.

 When ducting is horizontal it must be

laid to slope away at at least 1 cm per

metre. This is to ensure that

condensate cannot drain back into

the downdraft extractor.

 If the exhaust ducting is to run

through rooms, ceiling space etc.

where there may be great variations

in temperature between the different

areas, the problem of condensation

will need to be addressed. The

exhaust ducting will need to be

suitably insulated.