HP 1850R - ProLiant - 128 MB RAM Посібник з впровадження - Сторінка 32

Переглянути онлайн або завантажити pdf Посібник з впровадження для Робочий стіл HP 1850R - ProLiant - 128 MB RAM. HP 1850R - ProLiant - 128 MB RAM 35 сторінок. Proliant essentials foundation pack installation guide
Також для HP 1850R - ProLiant - 128 MB RAM: Посібник із запобігання помилкам (12 сторінок), Технічна Біла книга (12 сторінок), Оновлення мікропрограми (9 сторінок), Огляд (20 сторінок), Посібник з монтажу (2 сторінок)

Issue 20

Adding an EISA fibre channel controller

Description

Solution

With the server shut down and power removed from the server, install the EISA

fibre channel controller in the server by following the procedures detailed below

in the "Solution."

To install the controller:

1. Run the System Configuration Utility to add the controller and configure

changes to system BIOS.

2. Restart the server.

3. Start the hardware wizard by right clicking on My Computer | Properties |

Hardware.

4. Select Add/Troubleshoot a Device. No devices will be found.

5. Select Add New Device from the Choose Hardware Device screen.

6. Select No, I want to select hardware from a list.

7. Select SCSI and RAID Controllers.

8. Select HP and HP Fibre Channel Host Controller (non PnP).

9. Click Next | Finish.

10. Restart the server.

To load the driver:

After the restart completes, the Found New Hardware wizard will display.

This process resolves the device listed as Unknown Device under the Device

Manager tree. This Unknown Device, the HP Fibre Channel Controller /E,

requires the CPQFCALM.SYS driver

NOTE

The device HP Fibre Channel

Host Controller (non PnP),

displayed under Device Manager

with a yellow exclamation point,

can now be removed from the

Device Manager tree.