Miele T 1526 Технічна інформація - Сторінка 15

Переглянути онлайн або завантажити pdf Технічна інформація для Сушарка Miele T 1526. Miele T 1526 42 сторінки. Vented dryer
Також для Miele T 1526: Посібник з експлуатації (28 сторінок), Посібник з експлуатації (28 сторінок)

Друкувати сторінку

T 15xx Dryers

3.4

Program Option Buttons – T 1576

Low Energy (with Cottons Program)

Normal heater operation with a lower temperature.

Turbo (with Cottons Program)

Normal heater operation with a higher temperature.

Gentle

Uses a lower temperature and extended program time for care of delicate fabrics.

Buzzer

Enables the buzzer when the anti-crease stage of the program is reached.

3.5

Condensed-Water Drawer (Condenser Models Only)

General information:

Depending on the installation, condensed water is either pumped to an on-site

drain or collected in the condensed-water drawer.

The condensed-water drawer holds approximately one gallon of water. The water

should be emptied from the drawer after each program completes. Should the

container be full (or become filled during operation), the following occurs:

The "Empty out container" LED lights up

The buzzer sounds

The drying program stops and enters the cooldown cycle

To empty the condensed-water drawer:

1. Hold the cap open while emptying the water drawer.

2. Drain all water.

3. Install the water drawer back into the appliance. Ensure that it locks into place.

Warning!

The condenser water is not suitable for drinking.

3.6

Heat Exchanger (Condenser Models Only)

Note:

The heat exchanger should be cleaned at least twice a year.

1. Open the door. Locate the heat exchanger cover at the bottom left of the

appliance.

2. Turn the lever so that it is in a vertical position (refer to Figure 3-1).

Technical Information