Burk Plus-X 300 Посібник з монтажу та експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Передавач Burk Plus-X 300. Burk Plus-X 300 9 сторінок.

Network Settings

After logging in, the first page you will see is the Network

Settings page. Enter the network settings where

prompted. Note that the default Plus-X port of 45000 will

work in most installations. However, if you have

changed the Plus-X port during ARC Plus configuration

the Plus-X port you enter here should match that setting.

The ARC Plus IP address field calls for the IP address of

the ARC Plus that will host the metering, status and

command channels of the Plus-X 300.

Press the Update Settings button when you are

finished.

The Channels page is where you configure high and low

status thresholds for up to eight status channels, as well

as relay behavior for each of eight relay outputs.

In the Status Thresholds table, enter the input values

that will trigger status changes from low to high and vice

versa. The Lower threshold is the value below which a

voltage sample must decrease in order to change the

status from high to low. The Upper threshold is the

value above which a voltage sample must increase in

order to change the status from low to high.

Voltages between the lower and upper thresholds do not

cause a status change on the ARC Plus. For example, if

a voltage sample increases beyond the Lower threshold,

but does not reach the Upper threshold, the status indicated on the ARC Plus does not change.

Note that each input may be used as a metering channel, status channel or both. In other

words, an analog temperature reading may also drive "high temp" and "low temp" status alarms.

Plus-X 300 Installation and Operation Manual Rev C