Miele VACUUM CLEANER S179 POWERHOUSE PLUS FULLSIZE UPRIGHT Інструкція з експлуатації Посібник з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Пилосос Miele VACUUM CLEANER S179 POWERHOUSE PLUS FULLSIZE UPRIGHT. Miele VACUUM CLEANER S179 POWERHOUSE PLUS FULLSIZE UPRIGHT 25 сторінок. Miele operating instructions vacuum cleaner s179i

Друкувати сторінку

REPLACING PARTS

Use only genuine Miele replacement parts.

DISCONNECT THE CLEANER FROM THE ELECTRICAL SUPPLY.

If you have any questions, contact your local dealer / service agent.

Any service needed other than described in these Operating Instructions should be

performed by a Miele Service Center only.

To replace any of the following parts, place the vacuum cleaner in the horizontal position

by using the pedal. Then turn it over exposing the underside.

HOW TO REPLACE - DRIVE BELT

(Part # S01R4000) AND BEATER BAR

ASSEMBLY (Part # R98M9064)

1. Remove the 5 screws from the base plate

and lift it off. (Fig. 1)

2. Release the belt from the motor shaft and

lift the beater bar assembly to remove the

belt. (Fig. 2)

3. To reassemble the beater bar assembly,

simply return the belt to the motor shaft and

beater bar pulley.

Re-insert the bar mounts into their holders,

and turn the beater bar to ensure that the

belt has been seated correctly. (Fig. 3)

IMPORTANT: Make sure the belt is correctly

positioned in the selector lever.

4. Replace the base plate and re-fasten the

screws securely.

HOW TO REPLACE - BEATER BAR /

SIDE BRUSHES / BEARING SUPPORT A-B

1. First remove the base plate, drive belt and

lift out the beater bar assembly (as illustrated

above).

2. Remove the 2 screws at both ends of the

beater bar assembly and separate the

different parts as shown in the exploded view.

3. Replace any damaged part and reassemble

in reverse order.

HOW TO REPLACE HEADLIGHT BULB

1. Loosen the 2 screws from the lens cover

and remove it. (Fig.1)

2. Remove the old bulb by simply pulling it

forward, and replace it with a new one.

(Consult your local dealer /Service agent

for a suitable bulb) (Fig. 2)

3) Replace the lens cover and re-fasten

the screws securely

Fig. 1

– 10 –

Fig. 2

Fig. 3

1 - Beater bar

2 - Side brush B

3 - Side brush A

4 - Bearing support A

5 - Bearing support B

Fig. 2