Chroma CHCCRGBA Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Освітлювальне обладнання Chroma CHCCRGBA. Chroma CHCCRGBA 14 сторінок. Battery powered led fixture

Друкувати сторінку

Fx HSI [5ch]

StRGBI [5ch]

Standalon Master / Slave A / Slave

DEMO

DMX1 Look Select

RGBA [4ch]

To setup Stand-alone Master unit:

From the 'Control Mode' menu press Up/Down to access 'Standalon Master', press Enter, then Up/Down to

select 'Master', press Enter for 2 seconds to save settings.

To setup Slave unit:

From the 'Control Mode' menu press Up/Down to access 'Standalon Master', press Enter, then Up/Down to

select 'SlaveA' or 'SlaveB', press Enter for 2 seconds to save the settings. The output of the 'SlaveA' unit will

be identical to the Master unit while the output of the 'SlaveB' unit will be the same effects/mode but running

opposite of the sequence direction.

Configure the 'Output' of the Master unit for stand-alone operation. The display will indicate output assigned

and intensity level.

Output

For stand-alone operation and if DMX is not detected various output options can be selected: Press Up/Down

buttons and press Enter to select 'Output', press Up/Down to select from the options listed below. Press Enter

for 2 seconds to save and Exit to the main menu.

Off – snap to off

Hold – hold the last valid DMX state

Effect 1-99 – snap to the Effect of your Choice

Look 1-20 – snap to the Look of your choice

Chase 1-10 – snap to the Chase of your Choice

There are 99 pre-programmed Fx's in Color Charge. These programmed effects/looks are not editable.

Look Store

There are 20 internal pre-programmed Fx Looks for stand-alone operation. To preview a Look, press Up/Down

buttons to select Look Store, press Enter, press Up/Down buttons to select the desired Look. Configure the

'Output' to select and replay the desired Look.

To replay a Look with a DMX console, press Up/Down buttons to 'DMX1 Look Select' Control Mode, and press

Enter for 2 seconds. Use the console with the assigned channel to playback the various looks stored. (1-20

looks in 1 single channel)

Note: DMX has priority over internal Looks. Please refer to the List of pre-programmed Looks on page 8.

Looks can be recorded to the internal flash memory by users and will be preserved on power down. However,

looks will be returned to default setting if menu 'Reset to Default' is performed. There are two ways to record a

look:

Simple, with DMX console.

Set the Color Charge to the desired 'DMX1 Look Select'. Use a DMX console to adjust channel levels and

create the desired look or effect.

Press Up/Down buttons to access Look Store and press Enter.

Color Charge User Manual

HSI + 2Fx

RGBI (with *Magic Amber) + Intensity Fx

Stand-alone Master / Slave A / Slave B

Demo

1 DMX channel Look Select

RGBA

www.chroma-q.com

V1.4 September 2012