Allnet ALL168205 Експрес-налаштування - Сторінка 7

Переглянути онлайн або завантажити pdf Експрес-налаштування для Адаптер Allnet ALL168205. Allnet ALL168205 9 сторінок. Powerline ethernet adapter
Також для Allnet ALL168205: Експрес-налаштування (10 сторінок)

Друкувати сторінку
Product installation guide
Important:
Do not plug the device into a power strip or surge protector because these devices may consist of
filter and impair signal. Also avoid plugging the device right next to noisy sources such as cell
phone charger, Halogen light, noisy desktop computer, vacuum cleaner, etc. Both cases result in
poor transmission speed.
To install for the PC local Powerline network
1.
Use the supplied Category 5 Ethernet cable to connect Ethernet Bridge and your PC's Ethernet port.
2.
Plug the Ethernet Bridge to outlet.
3.
The POWER LED indicator will light on after plugging.
4.
You can repeat steps 1 and 2 for connecting as many other links depending on your needs
5.
The PL-ACT LED indicator starts blinking when the data communication proceeds on Powerline.
6.
The ETH-ACT LED indicator starts blinking when the data communication proceeds on Ethernet.
To share a xDSL or cable modem with Internet access service
1.
Connect one Ethernet Bridge to the broadband router
Plug the Ethernet Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into an available Ethernet port of the Router.
2.
Connect the other Ethernet Bridge(s) to the PC(s) to share the Internet access
Plug the Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into Ethernet port on the PC.
As wireless AP (Access Point) Extender
1.
Connect one Ethernet Bridge to the broadband router
Plug the Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into an available Ethernet port of the Router.
2.
Connect the other Ethernet Bridge to the AP
Plug the Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into the Ethernet port on the AP.
ALL 168205 Express-Setup © 2007 . All rights reserved
.
Seite 7