ALLNIC AUDIO M-3000 MK2 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач ALLNIC AUDIO M-3000 MK2. ALLNIC AUDIO M-3000 MK2 9 сторінок. Monoblock amplifier
Також для ALLNIC AUDIO M-3000 MK2: Посібник користувача (9 сторінок)
Друкувати сторінку
•
Analogue Power Tube Current Monitors. In order
to provide constant current (bias) monitoring for
the power tubes, Allnic uses a separate analogue
current meter for each tube. The meters make it
exceptionally easy to see the status of each tube at
any time and to respond immediately to any
variation in bias by use of the bias control knob for
the relevant tube. The meters offer a simple,
unambiguous indication of each tube's status
compared to conventional LED bias monitors.
•
"On-the-Fly" Triode/Pentode Switching. Switching
between triode and pentode operation can be
done "on-the-fly" at any time while the amplifier is
in use.
•
Beautiful 20KHz square wave response. See Figures
1-3.
Fig.1 Square Wave 50Hz
Fig.3 Square Wave 20KHz
Measured by LEADER LAG-126 Audio Signal Generator and KENWOOD CS-
4125 Oscilloscope.
•
As are all Allnic Audio products, the M-3000 MK2 is
fully RoHS (EU Reduction of Hazardous Substances
regulation)
compliant
materials.
WHAT'S IN THE BOX?
Please check that the pair (assuming you purchased a
pair) of shipping boxes contain the following:
•
One (1) each Allnic M-3000 MK2 monoblock power
amplifier
•
One (1) Owner's Manual
Fig.2 Square Wave 1KHz
in
construction
Note:
1)
The M-3000 MK2 ships with the tubes installed
2)
The M-3000 MK2 will work with most IEC type
aftermarket power cords. Of course, only you
can determine the power cord that works
most synergistically with the M-3000 MK2 in
your system.
3)
Be sure the M-3000 MK2 is labeled for the AC
voltage of your location. If it is not, please
contact Audiomentors.
We advise that you keep the boxes and other packing
materials that your M-3000 MK2 came in. It will be
useful if you sell your M-3000 MK2 or in the unlikely
event you need to ship it for service.
SAFETY
•
Remove ALL protective cushioning material
(cardboard around and "O" rings on tubes)
inside the tube chimneys before operation. The
tube chimneys should contain NOTHING except
the tubes.
•
Disconnect the power cord by pulling the plug,
not the cable.
•
Do not attempt any repairs. Do not remove the
unit's
authorization from Audiomentors.
•
Keep the power cord away from heat sources
•
Keep the unit away from liquids – do not allow
any liquid to enter the interior of the unit.
•
When the unit is moved from a cold to a warm
environment, allow sufficient time for any
condensation to evaporate before plugging the
and
M3000 MK2 into an AC connection.
•
Do not attempt any repairs.
CLEANING
A.
Chassis and glass
Use only a soft, lint-free cloth, dampened slightly with
water only (NO cleaning fluids!), to clean the faceplate,
chassis and tube chimneys of the M-3000 MK2.
B.
Connectors
5
chassis
cover
without
specific