ALLNIC AUDIO D-10000 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа ALLNIC AUDIO D-10000. ALLNIC AUDIO D-10000 16 сторінок. Digital to analog converter

Друкувати сторінку

each RCA (unbalanced) connector is to the left of the XLR (balanced) connector for that

•

channel; and

the left channel output connectors are to the right of the right channel connectors.

•

The left channel output connectors are labeled "L", and the right channel output connectors are

labeled "R".

You may have both balanced and unbalanced outputs connected at the same time without introducing

hum.

E. EXTERNAL CLOCK CONNECTION

The D-10000 OTL/OCL is equipped with BNC type in and out reference word clock connectors for use

with an external clock (See Figure 1).

INITIAL POWER-ON

Once you have your D-10000 OTL/OCL DAC in place, connected it to the electrical source, and all

connections have been made to your digital sources and preamplifier, you are ready to turn on

the power for your D-10000 OTL/OCL.

Before you power up the D-10000 OTL/OCL, though, be sure you have:

• checked that all your connections are snug

• selected the output connections that you want to use, single ended (RCA) or balanced (XLR), on

the switch on the back of the DAC

• turned the volume down or muted your preamplifier

To turn on the D-10000 OTL/OCL, press in the rocker switch on the left side panel near the front of

the unit and marked with on and off icons. To turn on the D-10000 OTL/OCL, press the top of the

rocker switch in. Of course, the "Off" position is the reverse, pressing the bottom of the rocker switch

in.

OPERATION

When the D-10000 OTL/OCL DAC is powered on, the balance meters on the left and right of the

front panel will illuminate (See Figure 2). When the D-10000 OTL/OCL is connected to a powered-

on source and the appropriate input for that source is selected, the LED in the top centre of the

front panel, labeled "Link", will illuminate. Note: In some cases, the "Link" LED might not

illuminate until signal is passing from the source.