Bürkert 8793 Інструкція з монтажу Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Позиціонери клапанів Bürkert 8793. Bürkert 8793 16 сторінок. Position controller and process controller with ii 3g ex ec ic iic t4 gc / ii 3d ex tc iiic t135c dc approval
Також для Bürkert 8793: Інструкція з монтажу Посібник з монтажу (16 сторінок), Додаткові інструкції (12 сторінок)
Друкувати сторінку
3.
auThorized use
The external position feedback is designed to be
installed in the Bürkert positioners types 8791, 8792
and 8793.
•
For use observe the conditions described in the chap-
ter entitled "Technical Data".
•
The device may be used only in conjunction with third-
party devices and components recommended and
authorized by Bürkert.
•
Correct transportation, storage and installation; and
careful use and maintenance; are essential for reliable
and faultless operation.
•
Use the external position feedback only as intended.
english
4
The external position feedback was developed with
due consideration given to accepted safety rules
and is state-of-the-art. Nevertheless, dangerous
situations may occur.
Failure to observe this operating manual, and its operating
instructions, as well as unauthorized tampering with the
device, release us from any liability and also invalidate the
warranty covering the device and accessories!
4.1.
Warranty
This document contains no promise of guarantee. Please refer
to our general terms of sales and delivery. The warranty is only
valid if the external position feedback is used as intended in
accordance with the application conditions.
The warranty extends only to defects in the
position feedback and its components.
We accept no liability for any kind of collateral
damage which could occur due to failure or mal-
function of the external position feedback.
english
6
4.
basic safeTy
insTrucTions
These safety instructions do not make allowance for any
•
contingencies and events which may arise during the
installation, operation and maintenance of the devices.
•
local safety regulations – the operator is responsible for
observing these regulations, also with reference to the
installation personnel.
General Hazardous Situations.
To prevent injury, ensure that:
•
Installation and start-up may be implemented by autho-
rized technicians only.
•
After an interruption in the power supply or pneu-
matic supply, ensure that the process is restarted in a
defined or controlled manner.
•
The device may be operated only when in perfect
condition and in consideration of the operating
instructions.
•
The general rules of technology apply to application
planning and operation.
5.
General informaTion
5.1.
scope of supply
Check immediately upon receipt of the delivery that the con-
tents are not damaged and that the type and scope agree
with the delivery note and packing list.
If there are any discrepancies, please contact us
immediately.
5.2.
contact addresses
Germany
Bürkert Fluid Control Systems
Sales Center
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
international
Contact addresses can be found on the final pages of the
printed operating instructions.
And also on the Internet at:
www.burkert.com
Bürkert
Type 8791, 8792, 8793
english
5
Company
Locations
english
7