ALLO PRI Gateway and Elastix Server Посібник з налаштування - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з налаштування для Сервер ALLO PRI Gateway and Elastix Server. ALLO PRI Gateway and Elastix Server 12 сторінок.

Друкувати сторінку

21. When finished click on the button SAVE. Now, to apply all the changes you have to

click on the orange button SAVE ALL as shown in Figure 4-18. The Allo gateway

will reboot automatically.

22. When it boots up, connect the PRI cable to the configured port in the gateway, and

go to the home page of the Allo PRI Gateway‟s WebUI. Check that the SIP trunk is

registered with Elastix and the PRI port is Active (see Figure 4-19).

23. Configure the IP (SIP) Phone with the correct parameters.

24. To test the Allo PRI Gateway, pick up the previously configured IP (SIP) Phone and

call to the PSTN by using the prefix configured in the Outbound Routes in Elastix

(8-number). The call must be established. On the other hand, when you receive a

Allo PRI Gateway Server Setup Guide

Figure 4-18. Save All

Figure 4-19. Save All

PaloSanto Solutions