Allo RemoteControl HSCU1C Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Система безпеки Allo RemoteControl HSCU1C. Allo RemoteControl HSCU1C 8 сторінок.

CONTROL PANEL PROGRAMMING:

General rules for programming:

• Modifications to settings must be confirmed by pressing the key OK; if not confirmed, the

modification is not saved.

• When the display shows the symbols this means that the user can scroll up through the list

using key

, or down through the list using key

• When the display shows the symbol OK this means that the user must confirm the operation by

pressing OK.

• When the display shows the letters Y or N this means that the function is active (Y = Yes) or not

active (N = No).

• To exit a function, press ESC.

• To cancel a setting, press C.

• To cancel part of a setting during entry, press

• To enter the hour, date, minutes and seconds, and wherever a numerical entry is required, use

the numerical keys.

• To associate telephone numbers with vocal and SMS messages, use the numerical keys.

• To select groups A, B and C use respectively keys 1, 2 and 3.

In the event of errors during entries there are no serious consequences;. the appliance simply

indicates the error with one or more beeps.

Initial start-up and configurations:

When the battery is connected, the display lights up and the control panel firmware version code

is shown on screen. Press any key to display the function to select the language used in the

control panel menus. Scroll through the languages using keys

and

and press OK to confirm.

From here on, vocal instructions are given; the messages are stored in the system memory

(located next to the GSM SIM card) and are in one language only, corresponding to the language

of the manual supplied with the control panel. Memories with other languages are available on

request.

Safety codes: "factory code", "user code" and "installer code":

The control panel has a factory code: "0000" to enable initial access to the programming

procedure. This code must subsequently be modified, and the two codes below must be

programmed:

• user code: (from 4 to 8 digits) enables activation of the manoeuvres and access to a number of

settings;

• installer code: (from 4 to 8 digits) enables access to all settings but not to manoeuvres

Caution!

Do not forget these codes or the control panel will need to be opened (generating a "tamper"

alarm), disconnect the power supply and reconnect, then initialise the system after entry of the

factory code (this operation does not delete the settings made). After entering the factory code

the system requests entry of the current time and date for the internal clock. The internal clock is

used in the event log and the timed programmer

Visit our website: www.Alloremotecontrol.com